SEAGATE BLACKARMOR NAS 110 SOFTWARE DOWNLOAD FOR MAC SERIAL

Subject: Re: Test on Seagate 440 NAS ( what do you exactly mean by 'bricked'? The U-Boot bootloader does not start? Is there any serial output? So I think I did make the connections (surface mount) and saw no signals.īut give me 24 hours and I’ll dig out the machine and refresh my memory. But my recollection is that the board didn’t have a the serial connector soldered on (like your photo). Please make sure to use a 3.3V cable (search for 'CA-42 USB').Ī 5V TTL cable may damage your NAS permanently. The following pinout has been published by user Mike Seeley /mjseeley (BA440) on Ideas? Has anyone else actually disassembled their 440 NAS? Maybe Seagate removed the serial interface connector to stop folks like us from hacking their systems? (I'm not eager to solder a new connector-not even sure what this empty space is intended for.) There is an empty space (labeled CN4, if I recall) that has no pins-just two rows of five solder points where a connector might go. So, there's nothing to connect a FTDI232r to. The motherboard on mine seems quite different from the 220.I can't find any serial connector/pins to control the boot process. I can't tell (from the above) whether anyone has actually had any success on a BlackArmor 440. Netboot_cmd=dhcp setenv serverip $/bootpImage go 0x4000000 Tftpboot- boot image via network using TFTP protocolīootargs=root=/dev/mtdblock0 mem=256M console=ttyS0 Saveenv - save environment variables to persistent storage Run - run commands in an environment variable Rarpboot- boot image via network using RARP/TFTP protocol Protect_spi - enable or disable serial FLASH write protection Protect - enable or disable parallel FLASH write protection Ping - send ICMP ECHO_REQUEST to network host Loady - load binary file over serial line (ymodem mode) Loadb - load binary file over serial line (kermit mode) Iminfo - print header information for application image Icache - enable or disable instruction cache I'm not very experienced with linux and changing kernels.īootelf - Boot from an ELF image in memoryīootm - boot application image from memoryīootp - boot image via network using BOOTP/TFTP protocolĭhcp - boot image via network using DHCP/TFTP protocolĮrase - erase FLASH memory via parallel interfaceĮrase_spi - erase FLASH memory via serial interfaceĮxt2load- load binary file from a Ext2 filesystemĮxt2ls - list files in a directory (default /)įatinfo - print information about filesystemįatload - load binary file from a dos filesystemįatls - list files in a directory (default /)

Seagate blackarmor nas 110 software download for mac